Installing a Brick Paver Walkway or Decorative Brick Blocks

The use of Bricks or Pavers to produce a pathway or patio matches a house in a method that is unmatched. In addition, installing a Brick or Paver sidewalk does not necessarily need a pro.

The key to setting up a Brick or Paver Walkway is to very first appropriately prepare the location where the bricks/pavers are to be installed. In addition, string lines must be strung on each side of the pathway.
As soon as the location has actually been dug down, 3/4" gravel stone must be laid in and tamped down securely. The height between the tamped down sand and the stringline ought to equal the thickness of the brick or paver.

Now that you have a stable base, position a 1" pipeline or ledger board the length of the sidewalk on either side of the sidewalk. Then using a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will produce a level surface area to lay the bricks/pavers.

Now put on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the prepared location. These strips will act as your sidewalk border and aid to preserve the integrity and shape of the sidewalk. You can get these plastic strip borders at a lot of home enhancement stores. The strips must be anchored down with 12" galvinized nails. You should sink these nails into the ground and through the strips every foot.

As soon as this is done, you can then start to lay the bricks/pavers. There are many patterns you can lay. I particularly like the Herring Bone pattern. The key to laying the bricks/pavers is to ensure that they interlock with each other. Constantly stagger nearby rows more info of bricks by 1/2 of a brick to interlock them. This will again assist maintain the integrity of the sidewalk.

Undoubtedly bricks/pavers will require to be cut or divided when developing the sidewalk. Unless you wish to buy or lease a costly wetsaw, I would recommend buying a simple brick/paver splitter. It is basically a chisel with a wide end that is the width of the bricks/pavers. To actually cut/split the brick/paver, lay it in a bed of sand and location the chisel at a 75 degree angle over the area where you wish to break the brick. Then utilizing a hammer strike the butt end of the sculpt securely. You might need to do this a couple of times. You may also wish to turn the brick/paver over and strike the opposite of the brick utilizing the hammer and chisle. Within one or two strikes the brick/paver need to break easily. If your walkway has curves you will need to buy/rent a wetsaw.

After installing the bricks, develop the outside edges with extra sand, and then shovel in the topsoil and pack down securely.
Spread stone dust over the new pathway and sweep into the fractures. This will complete the interlocking of the bricks and assist to get rid of any weed development.


In addition, installing a Brick or Paver sidewalk does not necessarily need a pro. The key to setting up a Brick or Paver Walkway is to first effectively prepare the area where the bricks/pavers are to be set up. Now that you have a stable base, put a 1" pipeline or ledger board the length of the sidewalk on either side of the walkway. These strips will act as your pathway border and help to preserve the stability and shape of the walkway. Inevitably bricks/pavers will require to be cut or split when developing the walkway.

Leave a Reply

Your email address will not be published. Required fields are marked *